Video and audio guide

Choose video and audio settings for Android tablets

Match resolution, codec, frame rate, bitrate, and audio settings to the Android tablet and playback application.

Updated September 4, 2026By

Download for WindowsWindows 7-11, 64-bit Download for MacmacOS 10.13 or later

The free version limits many processing operations to the first three minutes. Check compatibility and trial limits.

  • Media filesVideo or audio files
  • Set Android outputOutput matched to this workflow
  • An Android tablet checkVerify before batch processing

Problem and solution

Match the output to its destination.

Check the codecs inside the source container and the requirements of the target player, editor, or device before converting.

Choose settings for an Android tablet

Playback limits vary by tablet hardware, Android version, and media application. Test the source first, then create an H.264 MP4 compatibility copy only when the installed player cannot decode its container, video, audio, or subtitles.

Keep the source frame rate, use the tablet display resolution as a practical ceiling, and lower resolution or bitrate only when storage or decode performance requires it. Verify picture, audio, subtitles, seeking, and sync on the actual tablet.

Solution direction

Match resolution, codec, frame rate, bitrate, and audio settings to the Android tablet and playback application.

Recommended output

Use the output parameters required by this guide.

Only parameters stated by this workflow are shown. Match any remaining settings to the source and destination.

Container
MP4
Video
H.264 / AVC
Resolution
Match tablet or use 720p
Frame rate
Match source
Audio
AAC
Bitrate
Adjust after a test encode

Three-step workflow

Create and verify one test output before processing the full batch.

Match resolution, codec, frame rate, bitrate, and audio settings to the Android tablet and playback application.

01

Add the source

Load the video files

Open LosslessConverter and select Add Files. Add the video files and select the files required for this workflow.

LosslessConverter main window with the source controls visible
Source toolbarLoad the source from the main toolbar.
02

Match the tablet and player

Choose Android 1080P or 720P, then review settings

Open Output Format and choose Device > Android 1080P, or Android 720P when the display, storage, or decoder requires a smaller output. In settings, use H.264/AVC video, keep the source frame rate, choose AAC audio for broad compatibility, and lower bitrate only after testing picture quality and file size.

LosslessConverter Output Format menu with Android 1080P selected
Android 1080PSelect Device, Android, then Android 1080P.
03

Create the current output

Select Start All, then verify on an Android tablet

Choose an output folder and select Start All. When processing finishes, transfer the MP4 files to the tablet and verify picture quality, file size, audio, subtitles, seeking, and sync.

LosslessConverter main window with Start All ready at the lower right
Start AllRun the task, then verify the result.

Try it with your own media

Process one file, verify the result, then run the full batch.

The free version limits many processing operations to the first three minutes. Check compatibility and trial limits.

Download for WindowsWindows 7-11, 64-bit Download for MacmacOS 10.13 or later Browse Video & Audio Solutions

Primary sources

Official references for this workflow

Use these first-party references to confirm current format, application, or device support. Capabilities can change after this guide is updated.

Continue exploring

Compare a nearby format, device, or editing workflow before choosing the final output.